Mekko Technologies CR350 Computer controlled solder reflow oven   1. 300 mm (12") wide stainless steel ladder type mesh coveyor belt,     maximum recommended process width 270mm. 2. 5-zone processing oven (2 pre-heat zones 1 soaking zone,     2 peak zones). Closed loop PID temperature controlin each     zone. Heated length = 1.200 mm plus 600 mm cooling zone.     The processing chamber combines the benefts of forced     hot air convection with fast response ceramic panel emitters     (4-6 micron.) 3. 6,5 kw max. heater power, 415 V three phase.(other voltages     on request). 4. Cooling zone at exit from below the conveyor for optimum     processing. 5. Stainless steel internal oven and mesh conveyor belt.     The design of the processing oven ensures correct air flow     for convention currents, zone seperation and exhaust of     fumes. Outer shell and frame are powder coated mild steel.     The machine`s design allows easy acess and serviceability. 6. The machine is run from a computer control system. The PC     controller (not supplied) is used to create and store     programs for any different product applications.     The operator can load a program to control the set tem-     peratures and the conveyor belt speed. The monitor will     display the oven conditions, with color graphics of     each zone temperature. The system software, interface     unit and data cable are supplied for use on a     Pentium PC 7. On-screen profile display of substrate temperature using up     to three extended k-type thermocouples. The graphs may be     saved and printed on paper. 8. Floor standing maschine. Lenght = 2,350mm, width = 650mm     height = 1,400mm.   print